New / Additional Model Information

DLCCOAT 2 Flute Short Shank Type Long Neck Ball End mills VDLCLB.
New release of Long Neck Ball End mills for copper electrode Milling with V series Achieves excellent welding and wearing resistance resulting from the DLC coating.Achieves an unprecedented tool life with a special flute design for milling copper and aluminum.
Also compatible with shrink fit type holders.

HMGCOAT long neck ball is a new offering for the V series.
Offers higher wear resistance compared to HARDMAX, and is suited for hardened steels and high speed steels over 60HRC. It is very effective for high-performance and high-quality milling of high-hardness materials. It can be used in shrink fit holders.

UTCOAT long neck ball is a new offering for the V series.
Offers high toughness and lubricity, and suited for a wide application range from copper/raw materials up to 55 HRC.
It can be used in shrink fit holders.

The first V series lineup.
HARDMAX coating that achieves both hardness and heat resistance and well suited for hard materials over 40 HRC.
From Copper-Tungsten mold material to high hardness materials, it offers high performance and high quality milling.
These models can be used in shrink fit holders.

Newly released UDCRRS multi-flute radius end mills from our UDC series for milling cemented carbide. The 6 to 10 flutes and the 40 degree helix angle achieves low cutting resistance and offers deep cutting depth milling！Compared to the 2 flute models, the efficiency has been dramatically increased！
This contributes to the reduction in cycle time.

High efficiency and long life Ball End Mills for milling cemented carbide.
High-level treatment to reduce cutting resistance and mill at a high feed rate.
Wear resistance improved drastically with optimized diamond coating
Best for roughing and semi-finishing.

Long life Long Neck Ball End Mills for milling Cemented Carbide.
High-level treatment to reduce cutting resistance and minimize damage on cutting edge. Wear resistance improved drastically with optimized diamond coating. Best for roughing and semi-finishing.

A multi-flute long neck radius end mill with HMG coating is now available！
The multi-flute design and high rigidity due to the short flute length allows for stable milling even under extremely high efficiency conditions！In addition, in order to support high-precision milling, each tolerance has improved.

4 flute long neck radius series with HMG coating.
By adopting a strong negative rake angle, an extended tool life is achieved especially when milling high hardened materials of 60 to 70 HRC. The milling accuracy and surface quality are greatly improved!

Newly developed long neck ball with HMW coating is now available！Improved wear resistance from prehardened steels to 65HRC hardened steels.
In addition, we achieve very high accuracy with an outside diameter tolerance of 0/-0.006, and R accuracy of ± 0.003.

Optimized CBN material for milling of ultra-hard materials, with excellent wear resistance offers long tool life. Our unique tip design maximizes burnishing effect to enable super mirror milling. CBN long neck ball with an improved surface finish compared to conventional tools. Shank diameter tolerance, 0/-0.004 mm. Ball radius accuracy ±0.002 mm.

Optimized CBN material for milling of ultra-hard materials along with the improved cutting edge geometry allows for high precision milling and long tool life.
Excellent wear and chipping resistance ensures an outstanding surface roughness and precision throughout the long cycle time. 4 flute shape withstands high efficiency milling.
Milling time can be significantly reduced compared to 2 flute.